Ecumaster Accessories

The ECUMASTER USB to CAN is a USB interface that allows the user to connect to the CANbus network. It supports CAN 2.0A and CAN 2.0B standards. It...

Can bus keypad easily integrated with our PMU-16 and Ecumaster EMU Black. Very rugged and fully waterproof.8 available colours which are used as a ...

A CAN switch board is a tiny device to allow easy transfer of up to 8 switch states and 8 analog signals over the CAN bus. In addition to thi...

THE DATALOGGER for EMU CLASSIC and EMU BLACK is capable of recording all log channels (the same as on PC) with 25Hz on SDHC card (4GB or bigger req...

Thermocouple to CAN ModuleMeasuring exhaust gas temperature for each cylinder is a very cost effective way to monitor and check air distribution in...

Cradles for both EMU Classic and Black as well as for PMUs. Supplied with AV mounts. Photo is of EMU Classic Mount

Ecumaster Bluetooth module designed for communication with Ecumaster EMU Black via Can Bus. Enabling data to be displayed on android devices ...

Ecumaster Lambda to CAN controller is a compact device used to control a Bosch LSU 4.9 wideband oxygen sensor and transmit the lambda reading via ...

Bluetooth module designed for enabling data to be displayed from the Ecumaster EMU Classic or original silver box EMU on any android device or appl...

The Ecumaster Battery Isolator is a motorsport master relay device designed for FIA compliant battery isolation and engine shutdown. The device is ...

Can bus keypad easily integrated with our PMU-16 and Ecumaster EMU Black. Very rugged and fully waterproof.8 available colours which are used as a ...

This TPMS system easily connects to your car's data system via CAN. It monitors both tyre pressure and temperature, allowing you to set alarms for...

The device contains two independent H-Bridges, with over-current and short circuit protection, capable of 10A continuous current and 30A peak curr...

Can bus keypad easily integrated with our PMU-16 and Ecumaster EMU Black. Very rugged and fully waterproof.8 available colours which are used as a ...

The Ecumaster Battery Isolator is a motorsport master relay device designed for FIA compliant battery isolation and engine shutdown. The device is ...

Reading and processing wheel speed data is a common porblem in modern racing cars. Most modern ABS systems use active magnetoresistive sensors and ...

The DBW module is required to allow EMU to control the electronic throttle and it is connected to the an AUX or an INJ output.  up to 7A H-Bridge ...

This small box enable to connect up to 3 switches to one analogue input at Ecumaster products.Manufactured with very low tolerance resistors and al...

The CANBUS module is an add on module enabling CAN communication of Ecumaster EMU Classic with external loggers or dashboards. Additional 4 analog...

The Ecumaster Battery Isolator is a motorsport master relay device designed for FIA compliant battery isolation and engine shutdown. The device is ...

Today, motorsport success relies largely on data analysis. Important factors include tyre and brake disc temperatures. We are proud to introduce ou...

1m Comms cable for the EMU Classic to connect via USB to a laptop

This is our dual vanos module, this little box of tricks allows you to run the BMW dual vanos with your EMU Classic or any other ECU without the op...

Fully sealed potentiometer for use for example boost or traction control adjuster. Adjustable stops enabling to set any number positions from 2 up ...