Road Race Rally Engineering (RRR Engineering)

4-way circular alternator connector. Supplied as a kit with terminals. 

Honda 2 way connector, very common on B-series engines  Supplied with seals and terminals

Used on many applications mainly for sensors and solenoids. (Subaru, Honda) Also used for HV2 injectors Please note there are two other versions of...

Honda camshaft position sensor, reverse lock solenoid and many other. Supplied with terminals and seals

Connector used for manufacturing adaptors for FN2 Honda cars

This connector is used for Honda solenoids, K20 intake air temperature sensor, coolant temperature sensor, VVT, and many others Please pay attentio...

The very common connector in Honda's range of cars. Typical applications include; - Camshaft position - MAP sensor - TPS  -Crankshaft position sens...

Honda K20 knock sensor connector. Supplied with terminals and seal.

Honda K20 VTEC Connector Please note keyway Please note there are two other versions of this connector  Middle keyway available here  Top keyway av...

Connector 3 way with bottom keyway. Supplied with terminals and seals

  This connector is designed for use with the Honda pedal position sensor and comes with terminals and seals.  

Used for MAP and TPS sensor connectors on many Honda B series engines. Also, many other Honda applications. Supplied with seals and terminals

PWM controlled idle control valve. As used in the Lotus Exige S1, Lotus Esprit and more. Quality German aftermarket part. Mating connector availabl...

Lambda link loom is used with a wide range of our custom plug and play adaptors. Please select the lambda type you are intending to use.

Latching 30mm switch as used as a battery isolator switch on racing versions of Lotus models Rated IP67 at the FRONT, If the back of the switch is ...

Our kit will enable the easy installation of pressure sensors and connections to any stand-alone ECU or other data acquisition device. Please note ...

As the stock Toyota nuts are very shallow and easily rust making them hard to remove and easily rounded, we suggest when changing the exhaust manif...

We recommend to always install a new gasket when replacing the exhaust manifold to ensure a tight seal around the manifold.  Quality products by Reinz

NEW PRODUCT!!! We have noticed that valve springs are "just about" good enough for 7200rpm, so we have decided to lose some weight in the valvetrai...

Rectangular lambda 4.2 connector.  Supplied with terminals and seals

Most commonly used for Mitsubishi but also in some Toyotas. Supplied with terminals and seals.

The connector used with Mitsubishi for the knock sensor. Supplied with terminals and seals

Nissan 2 way idle control valve connector Blue keyway. Supplied with terminals and seals